If you own an RV camper, it’s essential to know how to light the pilot light on your RV water heater. The pilot light is a small flame that ignites the main burner and heats the water in your RV. In this article, we’ll provide you with a step-by-step guide on how to light the pilot light on your RV water heater.
Step 1: Turn Off the Gas
Before you begin, make sure to turn off the gas supply to your RV water heater. The gas valve is usually located outside of the RV and may require a wrench to turn off.
Step 2: Locate the Pilot Light
The pilot light is located inside the water heater access panel on the outside of your RV. Remove the access panel to expose the pilot light assembly.
Step 3: Prepare to Light the Pilot Light
Before lighting the pilot light, make sure to have a long lighter or matchstick and hold it near the pilot light assembly. Turn the gas control valve to the “Pilot” position and press down on the valve to release gas.
Step 4: Light the Pilot Light
Hold the flame near the pilot light assembly and press down on the gas control valve for about 30 seconds until the pilot light ignites. Once the pilot light is lit, release the valve slowly.
Step 5: Turn on the Water Heater
After lighting the pilot light, turn the gas control valve to the “On” position. Your RV water heater will begin heating the water in your RV.
Step 6: Replace the Access Panel
Once the water heater is lit, replace the access panel and make sure it is secure.
Conclusion
Lighting the pilot light on your RV water heater is a straightforward process that can be done with the right tools and knowledge. Remember to turn off the gas supply before attempting to light the pilot light and always use caution when handling gas. If you’re unsure about how to light the pilot light or encounter any issues, it’s always best to contact a professional RV service center like Etnoyer’s RV World in Highspire, PA. Their team of certified technicians can assist with any repairs or maintenance needed to keep your RV water heater functioning correctly.